The thickness of all glass curtain wall panel glass should not be less than 10mm; the thickness of laminated glass single piece should not be less than 8mm; the thickness of glass curtain wall rib section should not be less than 12mm, the section height should not be less than 100mm.

All steel structures are welded, and concealed works should be accepted. After the acceptance is passed, anti-rust paint is applied

When the glass curtain wall exceeds 4m (glass thickness 10,12mm), 5m (glass thickness 15mm), 6m (glass thickness 19mm), the all-glass curtain wall should be suspended on the main structure.

All glass curtain wall glass panels are generally large in size and should be installed with mechanical suction cups.

The main component of the all-glass curtain wall should have sufficient rigidity. When the steel truss or steel beam is used as the force-bearing member, the center line and the center line of the curtain wall are consistent with each other. The center line of the elliptical screw hole should be the position of the anchor rod of the curtain wall. Consistent.

The full glass curtain wall allows the silicone structural sealant to be injected on site.

A rigid horizontal force transmission structure shall be provided between the hanging clamp of the hanging glass curtain wall and the main structure.

All-glass panels shall not be in direct contact with other rigid materials. The gap between the board surface and the finishing surface or structural surface shall not be less than 8mm and shall be sealed with a sealant.

The thickness of the opening part of the aluminum profile shall not be less than 3.0mm, and the thickness of the closed part shall not be less than 2.5mm; when the wall of the profile hole and the screw are directly connected by the thread, the partial thickness shall not be less than that of the screw. Nominal diameter.

The thickness of the main force part of the section of steel profile shall not be less than 3.0mm.

For the eccentrically pressed column, the section width-to-thickness ratio shall comply with the corresponding provisions of Article 6.2.1 of JGJ102-2003 “Technical Specifications for Glass Curtain Wall Engineering”.